T1 PRI For PBX Telephony
A T1 PRI, also called an ISDN PRI, is a "Primary Rate Interface"
providing 23 individual digitized telephone lines plus data such
as Caller ID on a single digital telephone trunk line. A PRI line
is usually much less expensive than a dozen or more analog business
Bonding T1 Lines for Higher
While a standard T1 line provides 1.5 Mbps upload and download
bandwidth, lines can be bonded to create total bandwidths of 3
Mbps, 4.5 Mbps, 6 Mbps, 7.5 Mbps, 9 Mbps, 10.5 Mbps and 12 Mbps.
An advantage T1 lines have over fiber optic connections is that
they are available nearly everywhere without special construction.
What Are Pseudowires?
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
T1 Digital Cross Connect Systems
A digital cross connect system, often abbreviated DCS or DCAS,
allows you to switch traffic among your T1 lines. It will even
reach into the line to connect individual channels or timeslots
rather than the entire circuit. A manual device that cross connects
T1 lines is called a DCX or patch panel.
How do T1 and DS1 differ?
In general conversation, T1 and DS1 refer to the same thing. But
strictly speaking, T1 refers to a physical line circuit consisting
of 2 pair of copper wires with strict line signal specifications.
DS1 stands for Digital Signal level 1. DS1 is the service level
you get on a T1 line. However, DS1 also is part of the digital
signal hierarchy used in T3 lines and SONET fiber optic carriers.