T1 PRI For PBX Telephony
A T1 PRI, also called an ISDN PRI, is a "Primary Rate Interface"
providing 23 individual digitized telephone lines plus data such
as Caller ID on a single digital telephone trunk line. A PRI line
is usually much less expensive than a dozen or more analog business
phone lines.
Channelized and Unchannelized
T1 Lines
A T1 line may be configured as a single large pipe offering 1.5
Mbps data transport or as 24 individual channels of 64 Kbps each,
ideal for use as individual outside telephone lines to support
Key or PBX business telephone systems.
What Are Pseudowires?
A pseudowire is a virtual "circuit" that emulates a
traditional digital telecom service but on a packet switched network.
MPLS networks are especially suitable for pseudowires. By using
a pseudowire circuit, you can get the point to point connectivity
you desire without having to re-engineer your facilities to accommodate
a different protocol network.
T1 Digital Cross Connect Systems
A digital cross connect system, often abbreviated DCS or DCAS,
allows you to switch traffic among your T1 lines. It will even
reach into the line to connect individual channels or timeslots
rather than the entire circuit. A manual device that cross connects
T1 lines is called a DCX or patch panel.
T1 Line Bandwidth Explained
A T1 line is typically referred to as having a bandwidth of 1.5
Mbps. The precise line speed is 1.544 Mbps. However, the usable
bandwidth or payload is actually 1.536 Mbps. The difference is
8 Kbps which is used for line framing to keep the transmitting
and receiving ends of the circuit in synchronization.